![]() ![]() The wire management cavity bottom shall be fabricated from ¼” medium density fiberboard and shall be recessed 2” from each end to allow for wires to pass though. The wire management cavity shall be located at the rear 6” of the workstation, just under the wire management cavity cover section of the worksurface and shall be large enough to accommodate a large volume of power and data cables. The wire management cavity shall allow for the easy separation of data and power cables, both for individual stations and for connecting stations. Wire Management Cavity Characteristics – The wire management cavity shall allow easy and frequent access to power and data. The fastening system shall consist of two 14 mm diameter threaded metal inserts installed in the worksurface, two 3 ¼” steel connecting bolts screwed into the inserts, and two recessed 35mm diameter zinc die-cast/steel 1080 degree tightening cams countersunk at the appropriate stress points in the side of the side panel. The worksurface shall be anchored to the top of each side panel by an extra-strength tightening and fastening system. The worksurface anchoring system shall be strong enough to support frequent lifting or rolling of the station for rearrangement and reconfiguration. Both the worksurface and the wire management cavity cover edges shall be finished with 2mm contour banded pvc. The bottom surface shall be laminated with a backer sheet as a moisture barrier. The worksurface and wire management cavity cover shall be laminated with high-pressure laminate bonded to 1 1/8” high density particleboard. An optional key-lock shall be available for the wire management cavity cover. The wire management cavity covers shall be supported by a support brace/lock catch anchored to the back panel. Each wire management cavity cover shall be secured with two steel, European style hinges capable of pivoting 95 degrees. 1” deep rounded access points in the back of the wire management cavity cover shall allow power and data cables to pass through from the worksurface to the wire management cavity the access points shall be wide enough to serve as handles to open the wire management cavity cover. The cover shall remain attached to the station to prevent the cover from being misplaced. The cover shall open easily by rotating up-and-forward 90 degrees to provide access to the station’s wire management area. The rear 6” section of the worksurface shall serve as a wire management cavity cover. Worksurface/Wire management Cavity Cover – Worksurface shall either have a straight front profile or shall be designed to accommodate more effective conferencing and collaborative work by gradually sloping outward from each end, creating a wave profile shape. The computer workstations shall be either 25”, 28”, or 31” high. ShuttleSystem Computer Workstations – Wave/Straight ProfileĪll ShuttleSystem computer workstations shall be designed to allow for maximum flexibility in designing and reconfiguring different current and future classroom configurations and shall be specifically designed to be “docked” together with all other workstations in the system. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |